PEC Miniverter, Руководство пользователя

Страница: 3 / 16

- 3 -
1. UNPACKING AND STORING
As all units are shipped F.O.B. our plant, it is suggested that the shipping container be removed and
inspected for possible damage during shipment. If any damages are found, the claims must be
handled by the purchaser, and the carrier should be contacted immediately.
The P.E.C. Service Department should be notified if the nature of the damage is such that operation
of the equipment has been impaired.
If it is necessary to store the converter for a period of time before it is installed, be sure to place
unit in a clean dry area. To prevent excessive dust from accumulating on the unit, it is advisable to
protect the converter by placing it in the original shipping container.
The power supply must be handled at all times with the same care you would give any piece of
precision electrical equipment.
2. INSTALLATION
2.1 General
The P.E.C. Miniverter power supply (converter ) has been completely inspected and operated
under full load prior to shipment.
These units should be installed in a clean, dry ventilated location with the front and back of the
units at least 6" from the wall or other objects that would obstruct air flow. Do not install near
furnaces, radiators or any other sources of heat.
If the converter is installed in the operating area, it should be protected from splashing fumes, vapor
from the tank or drip from overhead piping. Do not install converter units in a location where they
are subject to moving lint, as this may clog up the air intake screen, thereby reducing air flow.
In many cases, the converter can be located in an adjacent room, thus isolating the unit from poor
atmospheric conditions existing in most manufacturing plants. When installed in a separate room,
particularly if the room is small, ample ventilation should be provided to keep room temperature
from rising excessively. It is absolutely essential to keep the ambient temperature below 105
° F.