Pearson OpScan iNSIGHT 70, Руководство по установке

Страница: 30 / 48

Installation of Host Computer and Peripherals
Standalone Installation
3-4
Installation Guide for the OpScan iNSIGHT 70 Scanner
7.
Complete installation of one 9-pin D cable from the Scanner Controller main
board to the
Com1
port on the back of the computer.
•
One end of this cable is already attached to the scanner's Scanner
Controller
main board at J9.
•
Connect the other end to the Com1 port on the back of the computer.
Once all computer cabling connections have been made, set the computer on the
shelf, coil any extra cabling under the computer shelf, and close the rear panels.
Work Table
The standalone OpScan i NSIGHT 70 scanner comes with a work table. This work
table is for the monitor, the keyboard, and the mouse. Instructions for assembling
the work table are provided by the manufacturer.
Monitor and Keyboard
Place the monitor, the keyboard, and the mouse on the work table. The monitor,
the keyboard, and the mouse need to be cabled to the computer. (See Figure 3-5
for cable locations.)
Monitor
1.
Connect the power cord:
•
Plug the female end of the power cord into the port labeled AC Outlet on
the back of the monitor.
•
Plug the other end (male end) into an AC wall outlet or power strip.
2.
Ensure that the monitor cable is connected. (See Step 6 under cabling.)
3.
Complete 5 BNC cable install from the bulkhead to the back of the monitor.
•
Connect one end of this cable to the bulkhead. Install the cable according
to the colors labeled on the bulkhead.
•
Connect the other end (15-pin) to the back of the monitor.
Keyboard and Mouse
1.
Plug the keyboard cable connector into the port labeled KEYBOARD located on
the scanner's back panel (bottom and second cutout from the left).
2.
Plug the mouse cable connector into the port labeled MOUSE located on the
scanner's back panel (bottom and second cutout from the left).