BACK PANEL
B
Power ON/OFF Switch: Connects and disconnects AC INPUT to the unit when
the power cord is connected between the AC INPUT and a 100-240VAC 50/60Hz
AC outlet.
C
AC INPUT & Fuse Holder: For connection to a 100-240VAC 50/60Hz AC outlet
using the included power cord. The fuse can be replaced after turning the
POWER switch OFF and removing the power cord from the AC INPUT. See the
SPECIFICATIONS section for the the specific fuse values required for each nova
model. Caution: using an improper fuse value may cause damage to the unit.
Peachtree Audio accepts no responsibility for any damage caused by the use of
improper fuse values.
D
IR INPUT: Accepts 3.5mm input from an Infra-Red (IR) repeater/distribution system.
Insert one end of a 3.5mm cable into this port and connect the other end to the output
of the IR repeater/distribution system. This input allows IR commands to control the
unit when the IR window on the front panel is not in “line-of-sight” of the remote control.
This is common when the nova is located in an enclosed cabinet or a different room.
Please contact us if you need more technical details regarding the IR protocol. Note:
To enable the rear panel IR input connector and disable the front panel IR receiver,
press the current input button 10 times in succession until the standby LED blinks
3 times. To disable the rear panel IR input connector and enable the front panel IR
receiver, repeat the procedure above until the standby LED blinks 2 times.
E
12V TRIGGER OUTPUT: Enables power on/off control of another product with a
12V trigger input. Insert one end of a 3.5mm cable into this output and connect the
other end to a 12V trigger input of the product to be controlled. Once connected,
both products should power on and off when using the nova on/standby button on
the front panel or remote control.
F
SERVICE ONLY: This is NOT a USB audio input! Reserved for service use. Note:
This port may also be used to provide 5V DC to power a USB device that draws
up to 5V/500mA (2.5 Watts) of power.
G
USB-A INPUT: Accepts digital audio input from compatible mobile devices. Works
with; iPhone 11 Pro and iPad Pro 10.5-inch.
H
USB-B INPUT: Accepts digital audio input up to 32-bit/384kHz PCM and 5.6MHz
DSD from a computer when the USB button is set to USB 2.0 (recommended for
9