PDI-P15LCDB User Manual
Document Number: PD196-096 Rev 2
- 9 -
Wall Installation
LOCATION GUIDELINES
The PDI-P15LCDB-WR TV is intended for entertainment purposes and should be installed in a
non-hazardous area in accordance with the National Electrical Code (NEC), ANSI/NFPA 70.
The PDI-P15LCDB-WR is capable of being mounted with several commercially available
mounting brackets utilizing the 100 mm VESA hole pattern. The PDI-P15LCDB-WR TV is able to
be wall mounted at the foot of a patient’s bed with the supplied bracket. Select a location that is
near a AC wall outlet and that does not expose the TV to bright room lights or sunlight if possible.
The LCD TV also requires connection of both CATV cable signal and across-room wiring for the
pillow speaker.
OSHPD (State of California Only)
The combined weight of the PDI-P15LCDB-WR TV, wall mount, and power supply totals less
than 20 pounds. At the time of this writing, the involvement of a written, submitted, reviewed, and
approved plan by OSHPD is not required to install the PDI-P15LCDB TV in the state of California.
However, the installer and architect in charge should verify current regulatory compliance.
CABLE SYSTEM GROUNDING
The coax cable system connected to the PDI-P15LCDB-WR TV should be grounded in
accordance with the National Electrical Code, ANSI/NFPA 70. The code provides guidelines for
proper grounding and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of the cable entry as practical.
WALL MOUNTING THE LCD TV WITH THE SUPPLIED BRACKET
1. Select a location on the wall
approximately 7 inches below the
ceiling. Position the Wall Bracket and
locate two mounting holes. Secure the
bracket to the wall (mounting hardware
is not included).
2. Position the Back Mount on the LCD
TV cabinet. Attach with four M4
screws provided.
3. Mate the Back Mount to the Wall
Bracket making sure the pivot bolts are
retained in the “L” shaped slot.
Secure with two 10x32 pilfer screws.
4. Slide the Power Pack into the metal
holster. Connect the DC Power Plug
into the “DC 12V” connector on the
back of the TV.
Connect the AC line cord.
5. The TV’s tilt can be adjusted by
loosening both Pilfer Screws, adjusting
tilt, and then tighten.
13 3/4” Vert x 15 1/2” Horiz
7”
Wall Bracket
NOT TO SCALE
AC
CROSS-ROOM
& CATV SIGNAL
WIRING
