User Manual for IP-PTZ643/645
37
2. Configure the NIC settings, including the
IPv4(IPv6) Address
,
IPv4(IPv6) Subnet Mask
and
IPv4(IPv6) Default Gateway
.
3. Click
Test
to make sure that the IP address is not used.(optional)
4. Click
to save the above settings
.
Notes:
If the DHCP server is available, you can check
to automatically obtain
an IP address and other network settings from that server.
The valid value range of Maximum Transmission Unit(MTU) is 100 ~ 1500. The
default value is 1500.
The Multicast sends a stream to the multicast group address and allows multiple
clients to acquire the stream at the same time by requesting a copy from the
multicast group address. Before utilising this function, you have to enable the
Multicast function of your router and configure the gateway of the network zoom
camera.
If the DNS server settings are required for some applications (e.g., sending email),
you should properly configure the
Preferred DNS Server
and
Alternate DNS
server
.
Note:
The router must support the route advertisement function if you select
Route
Advertisement
as the IPv6 mode.
5.3.2 Configuring Port Settings
Purpose:
If there is a router and you want to access the zoom camera through Wide Area
Network (WAN), you need to set the 3 ports for the zoom camera.
Steps:
1. Enter the Port Settings interface:
Configuration > Basic Configuration > Network > Port
Or
Configuration > Advanced Configuration > Network > Port
Figure 5-8 Port Settings
2. Set the RTSP port of the zoom camera.
HTTP Port
: The default port number is 80.
RTSP Port
: The default port number is 554.
HTTPS Port
: The default port number is 443.
SDK Port
: The default port number is 8000.