PCTEL SeeGull EXflex, Справочное руководство

Страница: 11 / 23

SeeGull
®
EX flex
®
Reference Manual
PCTEL, Inc., RF Solutions Page 11 Revision F
3. Installation
This section describes how to set up the
SeeGull EXflex Scanning Receiver.
3.1. Integration
There are sixteen (16) mounting holes (4-40
screw) on the chassis of the unit that are
used for mounting
in the user’s
enclosure/rack. Note that the maximum
depth of screw insertion from the chassis
exterior is ¼”. Refer to
Figure 3 and Figure
4 . Care should be taken when mounting this
unit in a system enclosure, rack, or case,
not to obstruct airways. Unobstructed
convection airflow is recommended.
Figure 3 - SeeGull EXflex Scanning Receiver top
view.
Airway intakes are located on the left and
right sides of unit as shown in
Figure 4 and
Figure 5 . Fan exhaust on rear of unit.
Figure 4 - SeeGull EXflex Scanning Receiver side
view
Figure 5 - SeeGull EXflex Scanning Receiver rear
view
Note: Do not obstruct air intakes or exhaust
on unit. Do not place the unit intakes next
to the exhaust of another heat source.
Side air intakes
Rear air exhaust