PCTEL SeeGull EXflex, Справочное руководство

Страница: 17 / 23

SeeGull
®
EX flex
®
Reference Manual
PCTEL, Inc., RF Solutions Page 17 Revision F
7. Troubleshooting
This section describes a few suggestions for
several common problems that might occur.
These suggestions are user serviceable.
7.1. No Power: Receiver LEDs not
Illuminated
If the SYS LED located on the face of the
scanning receiver is not illuminated, please
check the connection first, then the fuse,
which is located in the cigarette lighter end
of the power cord.
The fuse can be “blown” by a surge in the
portable or mobile battery system. A
temporarily shorted wire can also cause
other problems.
If the fuse is not operating normally, it will
open up, thereby disconnecting the input
power from the SeeGull EX
flex Scanning
Receiver. The fuse is the first line of
defense should any short circuit, large
spike, or other problems occur within the
power wiring circuitry. When the fuse
“blows”, there will be no power to the
receiver.
7.2. Changing the Fuse in the Power
Plug
If it is necessary to change the fuse in the
power plug, remove the cigarette lighter
plug end from the power source. See
Figure 13 for an illustration of the power
plug.
Loosen the fuse-holding finger nut by
turning it counter-clockwise until the plug
comes apart. The fuse is inside the power
plug housing and can be removed.
Figure 13 - SeeGull EXflex Scanning Receiver
Power Plug
Replace the fuse with an identical 3-amp
fuse.
Insert the new fuse in the housing and re-
assemble the plug by turning the knurled
finger nut in a clockwise direction. Tighten
this nut as tight as you can with your
fingers.
7.3. Received Signal Strength Appears
Low
If the received signal strength appears to be
lower than expected, it is likely that (1) an
incorrect antenna is being used, (2) an
antenna is not properly connected or (3) the
antenna or antenna cable is damaged.
Check that the antenna is properly
connected to the scanning receiver, and
that the antenna is of the correct frequency.
Note: Do Not Use Tools to Tighten.
Note: Check The Fuse in the Cigarette
Lighter Plug First!
Note: Only use a 3-amp fuse (EX flex ); any other
fuse value may cause severe problems with the
unit and void the warranty. In order not to violate
the safety approval of the receiver, the fuse
must be safety approved.
Pressure Clips
Positive Connection
Fuse Holding Nut