PCS DTC6, Инструкция по установке и эксплуатации, Страница: 8 / 9

Changing A Scene’s Preset Light Levels
The PCS 6-Button Controllers are specially designed to work in a UPB™ Lighting System
consisting of WS1D Wall Switch Dimmers. Pushbuttons on these controllers can be configured
to activate the Preset Light Levels and Fade Rates stored in the WS1D (scenes). Once
configured, the homeowner can easily adjust the Preset Light Level that gets activated by a
particular pushbutton by following this simple procedure.
Step Operation
1 Press the pushbutton on the 6-Button Controller to activate the currently stored Preset
Light Levels (scene) in the Wall Switch Dimmers.
2 Use the local rocker switch on the WS1D to set the new desired Preset Light Level.
3 Press the pushbutton on the 6-Button Controller five times quickly.
4 The WS1D will flash its lighting load one time to indicate that it stored the new Preset
Light Level.
Putting The 6-Button Controller Into Setup Mode
The 6-Button Controllers can be put into the Setup Mode (for UPB Setup Tool support) by the
following steps:
Step Operation
1 Press and hold the ON and the OFF pushbuttons for at least 3 seconds.
2 All of the LED Indicators will start to blink to indicate that it is in the Setup Mode.
Setting Factory Defaults
The 6-Button Controllers can be set back to factory defaults by the following steps:
Step Operation
1 Press and hold the ON and the OFF pushbuttons for at least 3 seconds.
2 All of the LED Indicators will start to blink to indicate that it is in the Setup Mode.
3 Press and hold the A and the D pushbuttons for at least 3 seconds.
4 The blinking will stop and the ON and the OFF pushbuttons will illuminate to indicate
that factory defaults have been set.
Page 7 of 8