PCE Instruments PCE-LOC 20, Руководство пользователя

Страница: 11 / 45

© PCE Instruments
9
Notes :
•
The PCE-
LOC 20’s memory and the internal clock/calendar use a small amount of
power although the calibrator is switched off. Remember to check the capacity of the
batteries from time to time although the PCE-LOC 20 is not in use.
•
Do not leave the PCE-LOC 20 without a battery pack or an empty battery for a long
time. The PCE-LOC 20 may lose its settings if it is left without a support voltage for an
extended period.
3 Start Up and Basic Operations
3.1 Power ON or OFF
To power ON the instrument, press and release the LOG/Power button until the display comes
on. During the power on sequence, the instrument shows a startup message and then shows the
applicable data.
To power OFF
the instrument, press and hold (≈ 2 seconds) the same button again. When the
power is off, the last set of configuration options stays in memory.
3.2 User Interface
Everytime the PCE-LOC 20 is switched on, the startup message ends in RUN Page.
4 display modes are available in the RUN page.
1. M Source
2. Measure Only
3. Source Only
4. Switch Test + Source
This display mode can be selected from MENU
→
DISPLAY Page.
In case of Dual Mode display, screen is divided into two parts. Due to that only few additional info
will appear on RUN Page. The information to be shown can be selected in Display Mode menu.