Install Other Devices
Note:
Make sure that the system can provide 1A on +5VSB (+5V
Standby) signal before using the Keyboard Power On function.
Function
Jumper Setting
Disable Keyboard Power On
Short Pins 1-2
Enable Keyboard Power On
Short Pins 2-3
Jumper JP5: Clear CMOS Memory
Use this jumper to clear the contents of the CMOS memory. You
may need to clear the CMOS memory if the settings in the setup
utility are incorrect and prevent your mainboard from operating.
To clear the CMOS memory, disconnect all the power cables from
the mainboard and then move the jumper cap into the CLEAR
setting for a few seconds.
Function
Jumper Setting
Normal Operation
Short Pins 1-2
Clear CMOS Memory
Short Pins 2-3
Jumper JP4: Select Processor Type
Use this 3-pin jumper select if you are using a Socket-370
processor (PPGA Celeron) or a Slot1 processor cartridge (Pentium-
II, Pentium-III, or SEPP Celeron).
Function
Jumper Setting
Select Slot1 Processor
Short Pins 1-2
Select Socket-370 processor
Short Pins 2-3
Install the Mainboard
Install the mainboard into the system chassis. This mainboard is
baby AT-sized and the I/O ports are provided on extension
brackets. In addition the mainboard can operate using an AT power
supply unit or an ATX power supply unit. This means that you
have a wide choice of cases that can be used by this mainboard.
Install the mainboard into the unit case. Follow the instructions
provided by the case manufacturer using the screws and mounting
points provided in the chassis.
15
