8
1. The pump wiring harness (a) has a 2-pronged plug. This
wiring harness needs to be connected to the switch wiring
harness (b) which includes the control switch. Make sure
the wire colors match (Figure 5).
2. The switch wiring harness (b) needs to be connected to
the battery wire harness (c) which includes the 15 amp
fuse (d). Make sure the wire colors match (Figure 5).
3. The battery wire harness needs to be connected to
a 12 volt DC power source. Connect the red wire to
a positive power source either to the vehicle's battery
terminal or at a power access point with at least 10 amp
capability. The black wire needs to be connected to a
good ground source or to the negative terminal of the
battery.
Wiring Harness
Figure 5: Wiring Harness
NOTE: The end of the wiring harness with the ring terminals (d) is detachable and can be left attached to the battery for convenience
purposes.
a
b
c
d
to pump
NOTE: The end of the wiring harness with the ring terminals
(d) is detachable and can be left attached to the battery for
convenience purposes.
4. Ensure that the power source is adequate, since an inadequate power source could cause numerous problems with your sprayer. If
you are using a power access point, ensure that it has at least 10 amp capability.
5. You now need to place the switch in a location where it is easily accessible for operation. Secure it so that it cannot fall or become
entangled and cause damage.
Mounting the Sprayer
