11
Troubleshooting
As you use your Spot Sprayer, it is possible that you will encounter minor problems that can be easily fixed. The following problems
and respective causes and solutions should cover most of the potential problems that you may face. If you are having problems
please attempt to use this troubleshooting section to solve the problem. If you are unable to fix the problem please contact the
original retailer for service.
Problems/Symptoms
Possible Causes
Solutions
Low Rate of Flow
Suction Strainer is partially clogged
Remove the suction strainer and rinse
Pump valves are damaged/bad
Replace the valves or contact the original retailer for service
and/or repairs
Low voltage
Use a power source rated at 10 amps and 12 volts
Pump Will Not Prime
Suction line is clogged
Inspect the suction line for debris
Suction strainer is clogged
Remove the suction strainer and rinse
Pump is damaged from chemicals not being
properly rinsed out
Contact the original retailer for service and/or pump
repairs
Pump Will Not Run
Fuse is blown
Replace the fuse on the wiring harness
Incorrect voltage
Use a power source rated at 10 amps and 12 volts
Pump pressure switch is malfunctioning
Replace the pressure switch or contact the original retailer
for repairs
No Spray Flow
Spray tip is clogged
Remove the spray tip and rinse out
Suction strainer is clogged
Remove the suction strainer and rinse
