Paxar 676, Руководство пользователя

Страница: 18 / 123

18
•
Printer Operation
Print Head Operation
The print head modules are to be opened and closed for threading of stock and ink.
The unit must also be opened to clean the head and for print head replacement.
Later in the manual, under separate headings, cleaning and replacement will be
covered.
For clarity the print stations have been assigned numbers one through three from left
to right. The far-left print station prints the back; it is print station number one. The
center and right print stations print on the top; they are stations two and three. Each
print station has an interlock switch that prevents the printer from running with any
or all print stations in the open position if that print station is assigned in the format
being printed. If a print station is open, the display will read HEAD OPEN
STATION X.
WARNING: DO NOT TOUCH THE PRINT HEAD WITHOUT WEARING THE
ANTI-STATIC GLOVES AND THE ANTI-STATIC WRIST STRAP.
To open the print heads for threading supplies or cleaning pulling the release knob
and then rotating the print head into the open latched position (see figure x). The top
two print stations have a pin in the rear to hold them open. The bottom print station
will remain open via gravity however it has a hole in the rear to hold the print head
in a slightly open position to act as a bridge when one is threading stock.
Figure 5 - Print Head Open / Closed
To close the head again pull the release knob and then rotating the print head into the
closed latched position (see figure 5).