2) Set Up Local Time Zone
The factory default time is set up as GMT and you should change it to your own local
time.
Example: Local time for each country shall be as per below from GMT
-08 USA, Canada
-03 Brazil……..
+00 GMT
+01 Western Europe, Germany, France, Italy…….
+09 Korea, Japan
You set up the local time by the following command.
* SMS command to The PATmicro :
T +01
(in case of Western Europe)
* The PATmicro will reply with this SMS :
HP=D001=SET TIME
Notes for command: You should allow a space between
T
and
+
3) First Fix of your PATmicro
When you start the PATmicro for the first time, PawTrax strongly recommends for
you to place it in a wide open sky area for about 10 mins at least to fix for the first
time.
Once it has fixed its initial GPS data subsequent fixes will be obtained a lot quicker,
known as ‘Hot Start’.
4) Cold Starts
Whenever the PATmicro is switched on from off, or after charging it will always
perform a ‘Cold Start’ to ensure it has an initial fix and is ready for whenever you
request a position. This cold start can take between 10 – 20 mins
We therefore recommend that it is placed outside with a clear view of the sky when
switching back on from an off condition.
IMPORTANT
PLEASE ENSURE THAT THE DEVICE HAS BEEN SET UP AND IS OPERATING
CORRECTLY AND SENDING LOCATION CO-ORDINATES BACK TO YOUR
PHONE BEFORE PUTTING IT ON YOUR PET. THIS CAN BE DONE SIMPLY BY
SENDING THE 'C' COMMAND – SEE BELOW
CHECK FOR CORRECT OPERATION EVERYTIME YOU PUT IT ON YOUR PET TO
ENSURE IT IS WORKING CORRECTLY.
