All commands to The PATmicro are sent via SMS text messages from your mobile
phone.
You need to tell it what mobile phone number you want to use to control it and to
receive location requests and battery low warnings etc
When you turn on The PATmicro for the first time the Blue LED may remain
illuminated depending on the type/providers SIM. If on, once you have registered
your mobile phone (the control phone) with the PATmicro, this will turn off.
1) Register
To register your ‘control phone’ send the following registration command by sms to
The PATmicro.
* SMS Command to The PATmicro :
R 1 0000 XXXX
* The-PATmicro will reply with this SMS to your phone :
HP=D001=REGISTERED
Notes for command:
“1” is a sequence ID of your device – this can be between 1 and 9 (used for ease of
identification should you want to control more than one PATmicro from your phone.
“0000”
is the default PIN/passcode (numeric 0)
“XXXX”
is your own PIN/passcode of choice (substitute XXXX with 1234 if you want
your new PIN to be 1234, or 9876 or 4444 etc)
** you should allow a space between command letter and each password as shown
above
You can change the control phone at anytime just by registering the new phone
using the above command and appropriate PIN numbers
