1
INSTALLATION INSTRUCTIONS
These doors are simple to install by any handy man with common DIY power
tools. Or you
can employ the services of a professional should you feel the installa on may
be beyond your experience.
Important:
Please read the instruc ons in full before you proceed to install. Should you
decide to install the door by yourself, it is important that the appropriate
safety gear is worn such as protec ve eye wear.
Remark:
The pet door flap can be adjusted with screws to control the length.
INSTALLATION STEPS:
STEP 1.
Chose the area that best suits your installa on.
STEP 2.
Mark out the preferred area (
as illustrated in Figure 1
).
The recommended height should be to have the top of the pet door opening
(flap) level with the shoulder height of your pet (
as illustrated in Figure 2
).
Take outside measurement of the inner frame of the door and add another ?”
(4-5 mm) to both width and height. This will provide suffi cient installa on
clearance.
STEP 3.
Once you have marked up the cut-out measurement, draw a line
around the perimeter using a pencil (
as illustrated in Figure 1
).
Drill a hole in each of the four inside corners using a minimum of 3/8’ (10mm)
drill bit (
as illustrated in Figure 3
).
Using a reciproca ng jigsaw, proceed to cut out the opening for the pet door
by cu ng along the pencil line (
as illustrated in Figure 4
).
STEP 4.
Once the hole is fully prepared, take the internal sec on of the door
and place a
generous bead of construc on silicon around the parameter of the frame leg
(
as illustrated in Figure 5
).
Now place a generous bead of silicon on the walls around the cut out to
provide a weather seal (
as illustrated in Figure 6
).
STEP 5.
Now insert the inner and outer frame into the cut out and clamp ghtly
together using builders clamps. (
as illustrated in Figure 7 & 8
). Double check
that the frames are level.
STEP 6.
Next a ach both the inner and outer frames together using screws or
pop rivets
provided. Pre drill holes for rivets with a 1/8” (3 mm) drill and ensure that they
are
evenly distributed. (
as illustrated in Figure 9 & 10
).
STEP 7.
Next place an addi onal silicon bead around the frame of the door to
provide a
nice neat nish and also around the internal joint in the internal pet door
frame. (
as
illustrated in Figure 11 & 12
).
EN
Содержание D06-115
Страница 4: ...3 A 1 B 1 C 1 D 8 3 20 E 6 4 40 ...
Страница 5: ...4 02 01 06 05 04 03 ...
Страница 6: ...5 D o n e 11 10 09 08 07 ...
