Page 3 of 12
screws S6 x 60
Installation Instructions
Wall Mounting:
1.
Determine the location were the solar station will be installed.
2.
Take the complete solar station out of the packaging.
3.
Take off the thermometer with handle by tearing strongly forward.
4.
Take off the front insulation shell of the solar station.
Leave the solar station assembled with the back insulation shell
5.
Mark the drill holes (distance 70 mm/ 2 ¾”) and drill them with an 8 mm/
5/16
” bit.
6.
Insert the attached plugs (S 8) into the holes.
7.
Attach the complete solar station to the wall by using the enclosed screws.
8.
Connect the piping between the solar station, storage and collectors.
All connections were tightened in the factory so that in general, it is not
necessary to tighten them again. Nevertheless it is important to carry
out a pressure test during the system setup
.
