Paul FOCUS 200 Base Series, Руководство по эксплуатации

Страница: 14 / 39

14
3 Instructions for the qualified personnel
Installation requirements
The following requirements must be assured for the correct installation:
• Installation in accordance with the general and locally applicable safety and installation regulations of the electric
and water utilities etc. and in accordance with the regulations stipulated in this manual
• Frost-free indoor area
•
Power supply 230 VAC, 50–60 Hz
• Sufficient space for connecting the ventilation tubes and for maintenance work
Transport and packaging
Proceed with care when transporting and unpacking the FOCUS unit.
Do not remove the unit packaging until right before installation! Before and during interruptions to
installation, the ventilation tube connections must be closed with the air connector sealing caps to
prevent construction site dust and moisture from entering.
Checking the scope of delivery
If the delivered product is found to be damaged or incomplete, please contact the supplier immediately. Included in the
scope of delivery are:
• HRU FOCUS with power cable;
Check the type label to make sure that the unit is the right one (type, version as per type label)
• Fastening sheet with two self-adhesive spacers (rubber buffers)
•
Control panel
• Translation of the original manual
• Product labels showing energy efficiency
•
Floor stand (optional)
Installation
The distances from adjacent surfaces shown in Fig. 8 must be observed. Please note that these clearances are not
shown to scale. The surfaces are allowed to be made from flammable materials.
Fig. 8: Distances from adjacent surfaces in mm
Make sure you leave at least 1 m clear in front of the FOCUS unit for subsequent maintenance work.
The FOCUS unit must be installed horizontally. Before mounting the unit on a wall, check that the wall construction has
the necessary load-bearing capacity (net weight of the FOCUS unit is 25 kg) and that the fastening sheet can be
mounted securely. With inappropriate walls, we recommend using the floor bracket (available as an option) to mount
the unit on the floor. This will keep any structure-borne noise transfer to an absolute minimum.
Wall mounting
Proceed as follows for wall mounting:
1. Mount the supplied fastening sheet A horizontally on the wall with the lugs B pointing upwards. Use the slotted
holes C to fix it in place with suitable fixing materials.