SmartNode Model 4830 DSL Series Overview
19
SmartNode 4830 DSL Series User Manual
1 • General information
Port Descriptions
The SmartNode 4830 DSL Series rear-panel ports are described in
.
Reset button behavior
For those SmartNode devices that have a
Reset
button on the rear panel, its behavior is as follows:
•
To restart the unit with the current startup configuration—Press for less than 1 second and release the
Reset
button. The SmartNode will restart with the current startup configuration.
•
To restart the unit with factory default configuration—Press the
Reset
button for 5 seconds until the
Power LED starts blinking. The unit will restart with factory default configuration.
•
To restart the unit in bootloader mode (to be used only by trained SmartNode technicians)—Start with
the unit powered off. Press and hold the
Reset
button while applying power to the unit. Release the
Reset
button when the
Power
LED starts blinking so the unit will enter bootloader mode.
Table 2. Rear panel ports
Port
Location
Description
10/100 Ethernet
ETH 0/0
Rear panel RJ-45 connector that connects the SmartNode to an Ethernet device (e.g., a
cable or DSL modem, LAN hub or switch).
Analog voice port,
FXS
Rear panel FXS RJ-11(6 position, 4 wire) connectors that connect the product with
an analog terminal (a telephone, for example) FXO port. EuroPOTS sup-
port (ETSI EG201 188).
Analog voice port,
FXO
Rear panel FXO RJ-11(6 position, 4 wire) connectors that connect the product with
an analog line (FXS port). EuroPOTS support (ETSI EG201 188).
G.SHDSL or ADSL
port
Rear panel Provides up to 11.4 Mbps (G.SHDSL) or 24 Mbps (ADSL) throughput,
supporting ATM QoS. Supports multiple PVC and DSLAM interoperabil-
ity.
The DSL LEDs are located on either side of the DSL port. ACT (when lit
or blinking) shows Activity, and LINK (when lit) shows that the DSL port is
connected.
Power
Rear panel The gateway is available in a DC or AC power input version, labeled
100–
240 VAC, 50/60 Hz, 200 mA
Console
Front
panel
Used for service and maintenance, the Console port, an RS-232 RJ-45 con-
nector, connects the product to a serial terminal such as a PC or ASCII termi-
nal (also called a dumb terminal).
