SmartNode Series Leased-Line Extenders overview
16
SmartNode 2290 Series User Manual
1 • General information
Figure 3.
SmartNode 2294
power input connectors
Ports descriptions
The SmartNode 2292 Series rear panel ports are described in
table 2
.
Reset button behavior
The SmartNode devices have a
Reset
button on the rear panel. It is used as follows:
•
To restart the unit with the current startup configuration—Press for less than 1 second and release the
Reset
button. The SmartNode will restart with the current startup configuration.
•
To restart the unit with factory default configuration—Press the
Reset
button for 5 seconds until the Power
LED starts blinking. The unit will restart with factory default configuration.
Table 2. Rear panel ports
Port
Location
Description
10/100 Ethernet
ETH 0/0 & ETH 0/1
Rear panel RJ-45 connectors (see
figure 6
on page 25) that connect the extender to an
Ethernet device (e.g., a cable or DSL modem, LAN hub or switch).
Analog voice port
Rear panel FXS RJ-11(6 position, 4 wire) connectors (see
figure 6
on page 25) that
connect the extender with an analog terminal.
Power
Rear panel The gateway is available in a DC or AC power input version (see
figure 3
), labeled as follows:
•
AC version (Internal power supply): 100–240 VAC, 50/60 Hz, 200 mA
•
DC version: 12 VDC, 1.25 A
Console
Front panel Used for service and maintenance, the Console port (see
figure 4
on page 17),
an RS-232 RJ-45 connector, connects the extender to a serial terminal such as a
PC or ASCII terminal (also called a dumb terminal).
External power supply connector (accepts 12 VDC, 1.25 A, from external AC adapter)
, 1.25A
Reset
Ports
ET
H 0/1
ET
H 0/0
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
