Introduction
25
Model 3088A/I User Manual
2 • Configuration
DSL Configuration Commands
The following commands are used to configure the DSL:
•
dsl set timeslots <3-89>:
Sets the DSL data rate. (The data rate is calculated by the equation:
data-rate =
#timeslots x 64k
.
•
dsl set annex <a|b>:
Set the annex.
•
dsl set lineprobe <enabled|disabled>:
Enable or disable line probe.
•
dsl set loopback <off|lal|rdl>:
Start or stop loopbacks.
•
dsl set pattern <off|511|511e>
: Start or stop PRBS generator and BER meter.
•
dsl set mode <co|cpe>
: Set the CPE as local (CO) or remote (CPE).
DSL Status Command
The
dsl show status
command shows the following DSL status information: link state, sync state, link speed,
error counters, line condition, noise margin, and test mode status.
DSL Clear Errcntrs Command
The
dsl clear errcntrs
command clears the error counters.
Remote Console
Provided that there is a DSL link to a second 3088A/I, a user may login to the first 3088A/I’s console and enter
the remote console command to access the second 3088A/I’s console. Using this remote console feature, the
user can configure and query the status of the second 3088A/I from a remote location. When the user is fin-
ished with the remote console, the logout command can be used to return to the local console.
Example Command Line Interface Session
3088A/I Command Shell
Password:
3088A/I> dsl show status
configuration:
dsl mode: co
dsl timeslots: 89
annex: b
line probe: disabled
status:
actual rate: 0
loss of signal: unavailable
noise margin: 0
snr: 0
sync state: out of sync
link state: idle
test modes:
loopback: off
pattern: off
errors: 0
