Installing the VoIP IAD
37
SmartNode 4830 Getting Started Guide
3 • Hardware installation
Installing the DSL interface cable. The SmartNode Model 4830 comes with an option for a G.SHDSL or
ADSL interface. Use a straight-through RJ-11 cable to connect the DSL port.
Installing the V.35 interface cable. The SmartNode Model 4830 comes with a V.35 interface presented on a
DB-25 female connector (see
figure 16
).
Figure 16. Rear view of the SN4830 showing location of V.35 interface connector
The signal pin-outs for the Model 4830 V.35 interface are shown in
table 7
.
The SN4830’s V.35 interface is wired as a DTE. No DCE configuration is possible. If you are directly connect-
ing the SN4830’s V.35 interface to third-party equipment that cannot be configured as a DCE, you must use a
Table 7. Signal pin-outs for the V.35 interface on the SmartNode 4830
Pin
Signal
Pin
Signal
1
Frame Ground
12
TXCb
2
TXDa
14
TXDb
3
RXDa
15
RXCa
4
RTS
16
RXDb
5
CTS
17
RXCa
6
DSR
18
LL
7
Signal Ground
20
DTR
8
DCD
21
RL
9
RXCb
24
EXTCa
11
EXTCb
V.35 serial port connector
Содержание SmartNode 4830 Series
Страница 52: ...52 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 53...
Страница 81: ...81 Appendix E SmartNode 4830 Series factory configuration Chapter contents Introduction 82...
Страница 83: ...83 Appendix F Installation checklist Chapter contents Introduction 84...
Страница 85: ...85 Appendix G Accessories Chapter contents Introduction 86...
