Installing the SmartNode extender
26
Model 2292 & 2294 Series Getting Started Guide
3 • Hardware installation
Installing an interface cable on the extender’s voice ports
The SmartNode extender comes with at least two voice ports (see
figure 6
) located on the back of the extender.
The voice ports are connected to analog devices via cables (see
figure 7
) terminated with RJ-11 connectors (see
figure 9
and
table 5
on page 27 for pin-out information).
Figure 6. Rear view showing location of Ethernet connectors and voice ports (SmartNode 2294 shown)
Figure 7. Analog connection
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
Ethernet connectors
Voice ports
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
RJ-11, male
RJ-11, male
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
Содержание SmartNode 2294
Страница 13: ...About this guide Model 2292 2294 Series Getting Started Guide 13...
Страница 19: ...19 Chapter 2 Applications overview Chapter contents Typical application 20 Leased line extension 20...
Страница 36: ...36 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 37...
Страница 52: ...52 Appendix E Installation checklist Chapter contents Introduction 53...