Installing the SmartNode extender
28
Model 2292 & 2294 Series Getting Started Guide
3 • Hardware installation
Installing the Ethernet cable
The SmartNode 2292 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see
figure 10
on page 28). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ether-
net ports (see
table 6
for port pin-out listing) via a cable terminated with RJ-45 plugs. Because the SmartNode
2294 Series does not have the MDX feature, a cross-over cable is required when connecting SmartNode 2294
Series devices to a host (see
figure 11
on page 29).
Note
Pins not listed are not used.
Figure 10. Connecting a SmartNode 2294 Series device to a hub
Table 6. Ethernet 10/100Base-T (RJ-45) port pin-outs (SmartNode 2294 Series)
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-
Hub
Straight-through cable
RJ-45, male
Tx+
Tx-
Rx+
Rx-
1
2
3
6
RJ-45, male
1 Rx+
2 Rx-
3 Tx+
6 Tx-
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
Содержание SmartNode 2292
Страница 13: ...About this guide Model 2292 2294 Series Getting Started Guide 13 ...
Страница 19: ...19 Chapter 2 Applications overview Chapter contents Typical application 20 Leased line extension 20 ...
Страница 36: ...36 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 37 ...
Страница 52: ...52 Appendix E Installation checklist Chapter contents Introduction 53 ...