Patriot Pro SXTi, Руководство по обслуживанию

Страница: 10 / 23

System Installation & Start-up Guidelines
Clear the installation area and carefully sweep the floor where the system will be installed.
Test home water pressure and make sure it is 30 – 75 psi static. A code-compliant pressure regulator must
be installed to protect the system on all municipal water installations.
Check to confirm that the water heater has adequate heat expansion protection to protect the system from hot water
damage.
Install the system, drain and brine tank overflow according to prevailing local code.
Bypass System.
Run bathtub cold to purge piping of debris and chemical residue from installation,
This will take approx. 5 minutes at 3gpm.
Leave bathtub running and slowly open the inlet valve to the system.
Slowly open the outlet valve from the system.
Observe flow of water from the bathtub. Water will become a dark brown/black color. This color is caused
by the system disinfectant/preservative as well as dust from shipping & handling. Allow water to run until
clear. Observe water for particles. If resin particles are found in the water, bypass the system and call tech-
support. - Leave the bathtub running.
Program the system according to the programming instructions in this manual.
Begin a cleaning cycle by
holding the recycle button for 3 seconds.
Advance the system through each cycle step by pressing the
recycle
button. Observe the system during
each cycle and then progressively advance to the next until the regeneration terminates.
Once the system has been advanced to normal operating mode, observe the flow of water from the bathtub
again for disinfectant and resin. Allow water to run clear – Turn off bathtub.
Test water at any softened faucet to confirm acceptable soft water production from the system.