Patriot Pro SXTi, Руководство по обслуживанию

Страница: 17 / 23

Your system is designed to address certain impurities in your water through the
processes of ion exchange and physical filtration. Your system should only be
installed on water that is microbiologically safe. For optimum performance, and to
ensure complete warranty protection the Patriot Pro SXTI System should only
be installed when the following criteria are met:
Minimum Maximum
Water Temperature 40 F 75 F
Water Pressure 30psi 80psi
Influent Water Hardness 0gpg 100gpg
Influent pH 6.7 8.7
Influent TDS 10 ppm 1000 ppm
Pathogenic Bacteria 0 CFU 0 CFU
Chlorine 0 ppm 1 ppm
Chloramine 0 ppm 1 ppm
Ambient Temperature 40 F 90 F
Evertech controller
Your Patriot Pro SXTI System is smart as a result of the exclusive Evertech control platform.
This advanced microprocessor control system incorporates the latest hardware and software to
ensure that your water is the very best that it can be. Your system can also be upgraded with
the latest software and hardware as they become available. See your authorized dealer for more
information.
During Service
The control center constantly monitors water usage in your home, learning your lifestyle and adapting
itself to ensure that you have a consistent supply of softened water.
The control center makes daily decisions about how and when it should clean itself using the latest
algorithms that consider your water usage habits, water hardness, and other programmed
parameters.
Your system will periodically perform an antibacterial deep cleaning. This cleaning cycle will occur
after a designated period of time (we recommend at least every once a week). This cleaning cycle will
inject Pur-Gard into your system and possibly even use salt to clean itself, depending on your
water
usage. If you haven’t used any water during that interval, the system will not use any salt during
the antibacterial cleaning cycle.
During a Cleaning Cycle
Once your system determines that it needs to be cleaned, it will initiate a cleaning cycle. The cleaning
cycle is controlled by the Evertech control center and cycle times will vary depending on your water
usage habits, the system operational history, and other programmed parameters. You should try to
avoid using softened water during this time, particularly after the percolation cycle.