38
CARE, MAINTENANCE AND STORAGE
Warning! Risk of injury! Before performing any operation unplug the power cord from the
wall socket.
Warning: Other maintenance and repair work than those listed in this manual, must only be
performed by an authorized manufacturer's service. When the cable is damaged it may only
be replaced by an authorized manufacturer’s service. Safety and operational reliability can
only be guaranteed when using original spare parts.
The power tool is almost maintenance-free
•
Occasionally grease the guiding roller (10) with a drop of oil.
•
Keep the power tool and the air vents clean and unplugged.
•
Make sure that no moisture reaches the inside of the power tool during cleaning.
•
Service repair consists of replacing worn carbon brushes only (contact your seller or a qualified
electrician).
Cleaning
•
Clean the power tool after every use. Remove dust, shavings, wood splinters, etc. Keep the saw
blade holder clean. Use brush or compressed air if necessary.
•
Clean the power tool with a wet cloth. Do not use cleaning agents or solutions; these can corrode the
plastic parts of the power tool.
Storage
•
Keep the tool in a dry and safe place. Remove the saw blade.
•
When you plan not to use the jigsaw for a longer period, please remove the batteries from the
battery compartment (15).
TROUBLESHOOTING
Problem
Possible cause
Solution
Jig saw does not work
Mains socket is not live
Check mains socket and/or
circuit breaker/RCD
Power cable fault
Check whether power cable is
disconnected or damaged
Unclean cut
Blunt saw blade
Replace saw blade
Saw blade is loose or
not inserted properly
Check and re-insert saw blade
properly
Base plate loose
Check and re-tighten screw of
the base plate
Motor overheated
Overload due to excessive
pressure to cut or prolonged
work at lower stroke rate
Allow the motor to cool down
by running the tool idle at
maximum speed for 3 minutes
Laser guide does not work
Low or discharged batteries
Replace batteries (2 pcs AAA)
