![background image](http://html1.mh-extra.com/html/patriot-lighting/lpt-1108/lpt-1108_instructions-manual_4003340004.webp)
ASSEMBLY AND INSTALLATION:
CAUTION:
• All electrical connections must be in accordance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with proper electrical practices, obtain services
of a qualified electrician.
• Turn off the main power at circuit breaker before installing fixture, in order to prevent
possible shock.
• Before cleaning fixture, turn off power and allow several minutes for the fixture to cool
down.
BEFORE YOU BEGIN:
Page 4
• The OUTLET BOX described in the following section is not provided. To install this
fixture, a standard OUTLET BOX needs to be pre-installed at the selected mounting
location. Power supply wires need to be run into the OUTLET BOX, extending
approximately 6
” from its opening. If an OUTLET BOX does not exist, contact a
qualified electrician to have one installed.
1. DISCONNECT POWER AT THE CIRCUIT BREAKER.
2. Thread the FIXTURE MOUNTING SCREWS into the provided holes of the MOUNTING
BRACKET, as shown. Thread the HEX NUTS onto the FIXTURE MOUNTING SCREWS, as
shown. Do not tighten the HEX NUTS at this time. (Fig. 1)
3. Pull the power supply wires out from the OUTLET BOX, and attach the MOUNTING BRACKET
to the OUTLET BOX, using the BRACKET MOUNTING SCREWS. (Fig. 1)
4. Strip approximately
¼” of insulation from each supply wire from the OUTLET BOX. Raise the
MAIN FIXTURE BODY to the wall, bringing the WALL PLATE close to the OUTLET BOX. Make
the following wire connections using the WIRE NUTS (Fig. 1):
WHITE (NEUTRAL) SUPPLY WRE
to
WHITE FIXTURE WIRE
BLACK (HOT) SUPPLY WIRE
to
BLACK FIXTURE WIRE
SUPPLY GROUND WIRE
to
FIXTURE GROUND WIRE
Wrap each wire connection with 2
” of electrical tape.
5. Place the WALL PLATE over the OUTLET BOX, making sure the FIXTURE MOUNTING
SCREWS feed through the holes on the WALL PLATE. Adjust the FIXTURE MOUNTING
SCREWS until they protrude out from the WALL PLATE
¼”. Remove the WALL PLATE and
secure the position of the FIXTURE MOUNTING SCREWS by tightening the HEX NUTS
against the MOUNTING BRACKET. (Fig. 1)
6. Carefully tuck all WIRES and WIRE NUTS into the OUTLET BOX. Place the WALL PLATE
back onto the FIXTURE MOUNTING SCREWS, and secure it into place using the LOCK NUTS.
(Fig. 1)
Содержание LPT-1108
Страница 1: ...Page 1 INSTRUCTIONS FOR LED WALL LANTERN MODEL LPT 1108...
Страница 8: ...Page 8...