Paton PRO-160, Руководство пользователя

Страница: 94 / 99

PATON PRO DC MMA/TIG/MIG/MAG
- 92 -
HAZARD OF HARMFUL GASES AND VAPOURS
- remove generated smoke and harmful gases from the working area with special
means;
- ensure sufficient supply of fresh air;
- vapours of solvents should not get into the radiation zone of the welding arc.
HAZARD OF SPARKLES
- remove flammable objects from the working area;
- do not perform welding works on containers where gases, fuel, oil products are or
were stored. Potential explosion hazard for residues of these products;
- in fire and explosion hazardous areas, observe the special rules in accordance with
national and international standards.
HAZARDS OF MAINS VOLTAGE AND WELDING CURRENT
- electric shock can be fatal;
- magnetic fields created by high-frequency current can have a negative effect on the
performance of electrical devices (e.g., a pacemaker). Persons with such devices should
seek the advice of a physician before approaching a welding area;
- the welding cable must be robust, undamaged and insulated. Loose connections and
damaged cables must be replaced immediately. An electrician must systematically check
the mains cables and cables of the welding unit for proper insulation;
- do not remove the outer casing of the unit during use.
INFORMAL PRECAUTIONS
- keep the instruction near the place of use of the welding unit at all times;
- in addition to the instructions, observe the applicable general and local safety and
environmental regulations;
- keep all instructions on the welding unit legible.
STRAY WELDING CURRENTS
- make sure that the ground cable terminal is firmly connected to the welding location;
- if possible, do not install the welding unit directly on an electrically conductive floor or
work table, use insulating gaskets.
REGULAR USE PRECAUTIONS
Check the unit at least once a week for external damage and the operation of the
safety units.