20
Regardless of which Burner cleaning procedure you
u s e , w e r e c o m m e n d y o u a l s o c o m p l e t e t h e
f o l l o w i n g s t e p s t o h e l p p r o l o n g B u r n e r l i f e .
1.
2.
3.
Use a wire brush to clean the entire outer
surface of each Burner until free of food residue
and dirt.
Clean any clogged ports with a stiff wire, such
as an open paper clip.
Inspect each Burner for damage (cracks or
holes) and if such damage is found, order and
install a new Burner. After installation, check to
insure that the Gas Valve Orifices are correctly
placed inside the ends of the Burner Tubes.
A l s o c h e c k t h e p o s i t i o n o f y o u r S p a r k
Electrode.
Figure 1
Figure 2
The location of the Burner Tube with respect
to the Orifice is vital for safe operation.
Check to ensure the Orifice is inside of the
Burner Tube before using your gas grill. See
Figure 2. If the burner tube does not fit over
the Valve Orifice, lighting the Burner may
cause explosion and/or fire.
WARNING
!
B end a s t i f f w i re , (a l i gh twe igh t co at
hanger works well) into a small hook as
shown below. Run the hook through the
Burner Tube and inside the Burner several
times to remove any debris.
Use a Burner Cleaning Brush or a bottle
brush with a flexible handle. Run the brush
through the Burner Tube and inside the
Burner several times, removing any debris.
Use an air hose to force air through each
Burner Tube. The forced air should pass
debris or obstructions through the Burner
and out the ports.
Cleaning The Burner Tubes and Burner Ports
To reduce the chance of "FLASH-BACK" you must
clean the Burner Tubes at least once a month in late
summer or early fall when spiders are most active or
when your grill has not been used for an extended
period of time.
Turn all Control Knobs to the full OFF position.
Turn the LP gas Tank Valve to the full OFF position.
Detach the LP gas Hose and Regulator Assem-
bly from your gas grill or disconnect the Quick
Disconnect Hose from the Natural Gas source.
Remove the Cooking Grids, Flame Tamers, and
Grease Trays from your grill.
Remove the Cotter Pin from the rear underside of each
Burner using a pair of long nose pliers.
Carefully lift each Burner up and away from the
gas Valve Orifice.
Refer to Figure 1 and perform one of these
three cleaning methods:
1.
2.
3.
4.
5.
6.
7.
•
•
•
ORIFICE
BURNER TUBE
BURNER PORT
BURNER
SPARK ELECTRODE
GAS COLLECTOR BOX
TO CLEAN BURNER TUBE,
INSERT HOOK HERE
GAS VALVE
ORIFICE
CONTROL
KNOB
CROSS
SECTION
OF MANIFOLD
GAS COLLECTOR BOX
SPARK ELECTRODE