17
Manually Lighting Your Grill by Match
To light your gas grill by match, insert a match into the
Manual Lighting Stick and follow steps 1 through 6 of the
Basic Lighting Procedures. Then, light the match and
place Manual Lighting Stick through the Lighting Hole on
the right side of the grill. See Figure 19. Turn the nearest
Main Burner Control Knob to the HIGH setting to release
gas. The Burner should light immediately.
To purge air from your gas line and/or reset
the Regulator excess gas flow device:
Opening the tank valve all the way or too quickly is
what triggers the Regulators safety device to shut
down gas flow which prevents excessive gas flow to
your grill. Lighting the Burner farthest from the fuel
source every time will help eliminate air pockets in
the Manifold. This procedure should be done every
time a new LP gas tank is connected to your grill:
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and body
a safe distance (at least 18 inches) from the
Lighting Hole or Burners, when lighting your grill
by match.
WARNING
!
•
•
•
2.
3.
Misalignment of Burner Tubes over Orifices
Correction: Reposition Burner Tubes over Orifices.
Obstruction in gas line
Correction: Remove fuel line from grill. Do not smoke!
Open gas supply for one second to clear any obstruc-
tion from fuel line. Close off gas supply at source and
reconnect fuel line to grill.
Plugged Orifice
Correction: Remove Burners from grill by pulling
Cotter Pin (beneath Burner) using Long nose
pliers. Carefully lift each Burner up and away
from Gas Valve Orifice. Remove the Orifice from
Gas Valve and gently clear any obstruction with
a fine wire. Then reinstall all Orifices, Burners,
Cotter Pins and cooking components.
If an obstruction is suspected in Gas Valves or Gas
Valve Bracket, please call the Customer Service
Dept. at 1-800-667-7313.
Turn gas off at source and turn the Control Knobs
to OFF. Wait at least five minutes for gas to clear,
then retry.
Check gas supply and connections.
Repeat lighting procedure. If your grill still fails to
operate properly, turn the gas off at source, turn the
Control Knobs to OFF, then check the following:
If the grill fails to light properly:
1.
•
•
•
Misalignment of Ignitor on Burner
Correction: Check for proper position of the
Electrode Tip as shown on page 15. The gap
between the Spark Electrode Tip and Spark
Receiver should be approximately 3/16". Ad-
just if necessary following the Electrode Check
procedure on page 15.
Disconnected Ignition Wires
Correction: Inspect the Ignitor Junction Box
found behind the Control Panel. Connect loose
Ignitor wires to Junction Box and try to light
grill.
Weak AA battery
Correction: Unscrew the Ignitor Cap and replace
the battery.
• Shut off gas supply to the gas grill.
• Turn the Control Knobs to OFF position.
• Put out any flame with a Class B fire
extinguisher.
• Open Grill Lid.
• Once the grill has cooled down, clean
the Burner Tubes and Burners accord
ing to the cleaning instructions found on
page 21 in this manual.
Should a "FLASH-BACK" fire occur in/or
around the Burner Tubes, follow the in-
structions below. Failure to comply with
these instructions could result in a fire or
explosion that could cause serious bodily
injury, death, or property damage.
WARNING
!
Figure. 19
Turn all Control Knobs to the OFF position.
Turn off the LP gas tank valve at the tank
valve.
Disconnect Regulator from LP gas tank.
Let unit stand for 5 minutes.
Reconnect Regulator to the LP gas tank.
Open Grill Lid or Side Burner Lid.
Turn the LP gas tank valve on slowly until
1/4 to 1/2 open.
Light the Burner farthest from fuel source
by turning its Control Knob to IGN then
pushing in the Control Knob. To light the
Side Burner push its Control Knob in and
turn to HIGH.
•
••
•
•
•
••
•
•
•
••
•
•
•
••
•
•
•
••
•
•
•
••
•
•
•
••
•
•
•
••
•
•
LIGHTING
HOLE
MANUAL
LIGHTING
STICK
MATCH