4
X
s
Preamp Owner’s Manual
WARNING, IMPORTANT SAFETY INSTRUCTIONS
Read these instructions, Keep these instructions
Heed all warnings, Follow all instructions and precautions
Water and moisture: Electrical devices should never be used near water (
as per example, near a bathtub, washbasin, kitchen sink, laundry tub, wet
basement or swimming pool. ) Care should be taken such that objects do
not have the opportunity to fall, and that liquid is never spilled onto or into
the device enclosure through openings. Electrical devices should never be
left exposed to the weather, dampness, splashing or dripping. Clean this
device only with a dry cloth.
Power Sources: An electrical device must be connected to a mains power
source in strict accordance with the supplied product owners manual and
local standards. Please verify that the AC mains voltage specified in the
product manual match those requirements indicated on the unit and the AC
voltage provided to your location by the power company.
Grounding: Adequate precautions should be taken so that the grounding
provisions built into an electrical product are never defeated. This product
is supplied with a polarized and grounding type IEC 320 power cord. An
IEC 320 grounding power cord has two blades, which conduct power and
a third grounding prong. The grounding prong is essential for personal
safety and proper operation of this product. If the grounding prong does
not fit your outlet, please consult an electrician and have the obsolete
receptacle updated before operating this device.
Power Cords: Pass Labs provides a power supply cord that meets all
legislated requirements for the market in which the product was originally
sold. If you choose to substitute an after-market product we urge you to
choose one that is fully safety rated by the necessary local authority.
The mains cord is intended to function as the safety disconnect for this
product and must remain readily accessible for this purpose at all times.
Power Cord Protection: Power supply cords should be routed so that they
are not likely to be walked on, abraded, or pinched by items placed on or
against them, paying particular attention to cords where they enter plugs or
exit from a device, or where they intersect traffic paths. Never walk on a
power cord. Never under any circumstance insert a cut or damaged power
cord into a mains power socket.
Power and Signal: Cables should never be connected / disconnected with
equipment powered up. Unplug mains cable before attaching or removing
signal or speaker cables Failure to heed this warning may damage or destroy
equipment and result in personal injury.
Ventilation: Electronic devices frequently run hot, but you should be able
to place your hands on them without discomfort. You must allow for this
