Release date: 24.07.18
rev 1.0 18
4 / 9
BEFORE STARTING INSTALLATION, PLEASE ENABLE THE PARKING SENSOR FUNCTION ON THE VEHICLE
BY USING OFFICAL FORD DISGNOSTIC TOOL.
FORD
CONNECTIONS
The harness supplied with PARKVIEW is split in 2 sec"ons, the first is composed by 4 wires to connect on the boot of the vehicle.
On the OEM 16 ways connector found it must to connect:
YELLOW to the +12vdc posi"ve wire posi"on 1
BLACK to the GND nega"ve wire posi"on 8
GREEN to the CAN H posi"on 6
WHITE to the CAN L posi"on 15
Once made the calibra"on connect the connector A in the connector of the parking sensors as above described.
Do not connect the BUZZER of the parking sensors, original sound is maintained. To power the parking sensors please connect it to the reverse lamp.
Once the connec"on are done the system is immediately ready to work, each "me the canbus line will wake up the LED of PARKVIEW will light GREEN to
indicate the correct behaviour of the module. Then by inser"ng the reverse parking sensors will ac"vate, consequently PARKVIEW will ac"vate the visualizing
on the OEM radio. With some radio MUTE is managed directly by the radio. By removing the back gear the visualizing will be interrupted.
By switching on the parking sensors, Parkview led will generate some red/green flashes confirming the right working.
R 1 3 5
2 4 6
R 1 3 5
2 4 6
PARKVIEW CF0006UNPS51
CANBUS MODULE TO VIZUALIZE PDC ON CAR DISPLAY
COBRA PS 0158
INSTALLATION MANUAL
45’
Remove the bulkhead in the
trunk, behind it there are 3
connectors wrapped in a sponge
Remove the connectors from the
sponge and locate the beige 16-way
connector.
1
FRONT VIEW
9
8
16
Once the calibra"on has been performed,
disconnect the BUZZER and connect connector
A: the system is now ready to operate.
BUZ 4 3 2 1
A
A er making the connec"ons, connect the
Parking Sensor KIT BUZZER and the PARKVIEW
wiring connector B and calibrate the Cobra
system as usual.
BUZ 4 3 2 1
B
A