012-15856A
PS-3401
Instruction Manual
6
1-916-462-8384
800-772-8700
Trial run
•
Make sure the required voltage corresponds to the mains voltage.
•
Ensure the socket must be properly grounded.
•
Switch on and start initializing.
•
Add sample into the container with an appropriate stirring bar.
•
Place the container on the heating plate.
•
Set the target speed and start stirring.
•
Observe the stirring bar operation.
•
Set the temperature and start heating.
•
Connect the external temperature sensor.
If the above operations are normal, the device is good to run. If these
operations are abnormal, the device may probably be damaged during
transit, please contact manufacturer/supplier for technical support.
Warning!
DO NOT move the container when the device is working.
Heating
With the digital temperature control, the machine has two separate safe
circuits. The hotplate is kept at a constant temperature by a digital control
circuit. The hotplate temperature can also be monitored by another
adjustable safe circuit. The two temperature sensors (PT1000) internal
for temperature control are built into the hotplate.
•
Set temperature by the temperature setting knob.
•
Heating is switched on/off by pressing the temperature setting.
•
The set temperature of last operation will be displayed when the
machine is switched on. Normally, the set temperature and the
actual temperature may probably have some differences:
-
Hotplate center and outer edge
-
The sample inside the container and the container