Getting Started
2-8
2.5 Install Hard Drives
This section describes the physical locations of the hard drives supported by
the SurfRAID TRITON Mini and gives instructions on installing a hard drive.
The SurfRAID TRITON Mini supports hot-swapping allowing you to install or
replace a hard drive while the SurfRAID TRITON Mini is running.
1.
Pull out an empty disk tray. (You can install in any available slot.)
2.
Place the hard drive in the disk tray.
3.
Install the mounting screws on each side to secure the drive in the mo-
bile rack.
4.
Slide the tray into a slot until it clicks into place. The HDD status LED
will turn red at relative position of front panel.
5.
If the HDD status LED did not turn green, check the hard drive is in
good condition.
6.
If the hard drive is not being accessed, the HDD access LED will not
illuminate. The LED blinks only when being accessed.
Содержание SurfRAID TRITON Mini
