10
* Option:
Only valid for some models.
Note:
For hobs with a wok
;
Adjusting or replacing the bypass nozzles
The bypass nozzles regulate the minimum flame height of the
burners.
Preparation
Shut off the gas supply.
:
Risk of electric shock!
Disconnect the appliance from the power supply.
1.
Turn off the switches on the control panel.
2.
Pull of all handles carefully upwards.
Adjust the bypass nozzles for the conversion from natural
gas to liquid gas, or replace these:
For versions with direct access to bypass nozzles (optional):
Tighten the bypass nozzles as far as they go via the drain
openings in the hob.
The burner's bypass nozzles are adjusted via the drain
openings that can be seen when the control knob is removed
from the control panel. Put a flat-blade screwdriver (no. 2)
through the drain holes (ensure that you do not damage the
cables) and tighten the bypass nozzles as far as they will go.
For designs that do not have direct access to bypass nozzles
(optional):
To reach the bypass nozzles, you must remove the hob. See
section "
Removing the hob
".
After the hob has been removed, remove the ignition group
from the taps.
The bypass nozzles must then be tightened as far as they will
go.
Reinsert the ignition group and install the hob as described in
the section "
Installing the hob
".
Adjust the bypass nozzles for the conversion from liquid gas
to natural gas, or replace these:
All of the burner nozzles in the appliance must be replaced.
See section "
Removing the hob
".
After the hob has been removed, remove the ignition group
from the taps. You must then carry out the steps in the section
"
Replacing the bypass nozzles
".
Then reinsert the ignition group and carry out the steps in the
section "
Installing the hob
".
Содержание G20
