Parmco HX-1-9NF-CER-T, Инструкция по установке и эксплуатации

Страница: 10 / 22

7
Using your Ceramic Hob
To start cooking
You will hear a beep each ti me a touch is registered on the control panel.
1. Touch the ON/OFF control. All the indicators show “-“ or “- -“
• Once powered on, the hob will beep once and all cooking zone indicators will
light up brie fl y, indica ti ng that the ceramic hob is now on.
Note: if no func ti ons are selected within 1 minute of turning the hob on, it will
automa ti cally shut down.
2. Place a suitable pan on the cooking zone that you wish to use.
• Make sure the bo tt om of the pan and the surface
of the cooking zone are clean and dry.
3. Touch the “-“ or “+” controls below the corresponding cooking zone and it will
Flash. Touch the “-“ or “+” controls again to set the heat level.
•
If you don’t choose a heat se tti ng within 1 minute, the ceramic hob
will automa ti cally shut down. You will need to start again from step 1.
•
You can modify the heat se tti ng at any ti me during cooking by touch the “-“ or “+”
controls.
Note: If using mul ti ple cooking zones, to change the heat se tti ng, simply touch the “-“ or “+”
controls below the desired cooking zone to change the heat se tti ng.
4. To use the dual cooking zone, touch “-” or “+” of the dual cooking zone, then touch the dual
cooking zone symbol
on the control panel.
This will ac ti vate the outer ring of the zone. Use the “-“ or “+” controls to adjust the hea ti ng
level.