EN
1. Where installed, remove battery hatch from
fuselage.
2. Turn aircraft over so the bottom of the fuselage
faces up.
3. Put the wing’s guide pins in the fuselage
plate holes.
4. Where used, put aileron and retractable landing
gear connectors in the hole in the fuselage.
Make sure connectors do not fall out of the
fuselage after wing is installed.
5. Align and attach wing to the fuselage using
two screws.
CAUTION:
Do NOT crush or otherwise
damage wiring when attaching wing to fuselage.
6. Turn assembled fuselage and wing so the
bottom of the wing is down.
7. Connect servo connectors to the receiver or
Y-harnesses. There is no difference between two
connections on a Y-harness. Left and right servo
connectors do not have to be connected to
a particular side of a Y-harness.
8. Where needed, disassemble in reverse order.
1
2
3
• Lower throttle and
throttle trim to
lowest settings.
• Connect battery
to ESC.
Continuous LED
Series of tones
Power on
Transmitter
Wait 5
seconds
NOTICE:
Use of CA accelerant on your model can damage paint. DO NOT wipe accelerant from model, but let accelerant evaporate.
3 X 25mm (2)
Before Flight
Installing Wing
6
Installing a Receiver
Battery Selection and Installation
1. Remove the wing to install a receiver.
2. Install your park fl yer or full range receiver in the fuselage using hook and
loop tape or double-sided servo tape.
3. Attach the elevator and rudder servo connectors to the appropriate chan-
nels of the receiver.
4. Attach the aileron Y-harness to the aileron channel of the receiver.
5. Attach the ESC connector to the throttle channel of the receiver.
1. We recommend the ParkZone 2200mAh 11.1V 25C Li-Po battery (PKZ1029).
2. If using another battery, the battery must be at least a 25C 2100mAh battery.
3. Your battery should be approximately the same capacity, dimensions and
weight as the ParkZone Li-Po battery to fi t in the fuselage without changing
the center of gravity.
