Parkside PTSS 1200 B1, Оригинальное руководство пользователя

Страница: 12 / 28

PTSS 1200 B1 GB
│
IE
│
NI
│
9 ■
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cuts
♦ When making a "plunge cut" which is not at
right angles, secure the base plate of the saw to
prevent any lateral movement. Lateral movement
can cause the saw blade to jam, thus causing
a kickback.
♦ Adjust the desired cutting depth as described
above.
♦ Place the appliance on the workpiece.
♦ Avoid kickback and place the rear edge
against a stop (as referenced in the section
"Plunge cutting with guide rail").
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and and pivot it.
NOTE
► The cut width marking on the side of the
blade guard shows the front and rear cutting
point of a 165 mm at maximum cutting
depth. This applies both to plunge cuts with
guide rail and plunge cuts without guide
rail .
Sawing (with guide rail)
Right-angled sawing with guide rail
♦ Place the guide rail with the foam rubber
element on the workpiece.
♦ Place the appliance with the groove onto the
guide rail .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and and pivot it.
Mitre angles up to 45°
♦ Apply the guide rail with the foam rubber
element onto the workpiece.
♦ Place the appliance with the groove onto the
guide rail .
♦ Adjust the cutting angle as described.
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance
with the front part of the base plate on the
workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cutting with guide rail
♦ Place the guide rail with the foam rubber
element on the workpiece.
♦ Place the appliance with the groove onto the
guide rail .
♦ Adjust the desired cutting depth as described
above.
♦ Place the rear edge (as much as possible)
against a stop.
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and and pivot it.
NOTE
► The cut width marking on the side of the
blade guard shows the front and rear cutting
point of a 165 mm cutting blade at maximum
cutting depth. This applies both for plunge
cuts with guide rail and plunge cuts
without guide rail .
Further applications are not permitted.