10
IE
NI
Fastening the control unit (Fig. A)
2. Remove the screw (16) from the clamp
in the wall bracket (15).
3. Hang the control unit (8) in the wall
bracket (15).
4. Secure the control unit (8) to the wall
bracket (15) with the screw (16).
Connecting the connection hose
5. If necessary, screw the quick-connect
adapter (19) with the sealing ring (20)
onto the thread on the pump (11).
6. Plug the connection hose (17) onto the
quick-connect adapter (19).
Fastening to the rain barrel
As an alternative to the wall bracket (15),
you can also attach the control unit (8) to
the rain barrel.
1. Hang the clip (27) in the control unit
(8) instead of the wall bracket.
2. Attach the clip (27) to the edge of the
rain barrel.
Immersing the pump
Be careful not to hold or
hang the device by the con-
nection cable. There is a risk
of electric shock due to dam-
aged connection cables.
• Use the plastic hook (18) or the con-
nection hose (17) to immerse or raise
the pump.
• Place the pump in the rain barrel. Note
the maximum immersion depth of 1.8
m due to the length of the connection
hose (17).
• Hang the plastic hook (18) on the edge
of the rain barrel.
• Wrap the excess connection cable (10)
around the pump and fi x the cable to
one of the cable clips (12) on the side
of the pump.
Beware of dirt and sand accumu-
lating at the bottom of the barrel
over time, which could damage the
pump. We recommend placing the
pump on a brick.
Shortening the connection
hose
(Fig. B)
Shorten the connection hose (17) to avoid
excess hose length.
1. Push the connection hose (17) out of
the plastic hook (18).
2. Turn the coupling nut (25) from the con-
nector (24).
3. Pull the connection hose (17) out of the
connector (24).
4. Shorten the connection hose (17) to the
desired length by cutting off the excess.
5. Reassemble the connection hose (17)
with the connector (24) and the plastic
hook (18) in reverse order.
Connecting the pump to the
control unit
1. Press the plug (14) of the connection
cable (10) onto the connection socket
(9) of the control unit (8).
2. Screw the coupling nut of the plug (14)
onto the connecting socket (9).
Inserting/removing the
battery
(Fig. C)
1. Push the bracket (1) upwards.
2. Fold open the battery cover (26) of the
control unit (8).
3. To insert the battery (21) into the de-
vice, slide the battery along the guide
rails into the device. You will hear them
click into place.
