Parkside PFDS 33 B4, Инструкции по эксплуатации и безопасности

Страница: 40 / 141

40 GB/NI/IE
Assembly
†
Push the flux-cored wire through the wire
feed guide 26 (see Fig. J).
†
Guide the wire along the feed roll
29
and push it into the cable assembly
holder
31
(see Fig. K).
†
Swivel the thrust roller unit
28
towards
the feed roll
29
(see Fig. L).
†
Mount the adjustment
27
screw
(see Fig. L).
†
Set the counter pressure with the adjust-
ment screw. The welding wire must be
firmly positioned between the thrust roller
and feed roll
29
in the upper guide
without being crushed (see Fig. L).
†
Switch on the welding device on the
main
5
switch.
†
Press the torch button
12
.
†
Now the wire feed system pushes the
welding wire through the cable assembly
13
and the torch
11
.
†
As soon as 1 – 2 cm of the wire
protrudes from the torch neck
32
,
release the torch
12
button again
(see Fig. M).
†
Switch off the welding device on the
main switch.
†
Screw the welding nozzle
17
back on.
Make sure that the welding nozzle
17
matches the diameter of the welding
wire used (see Fig. N). When using the
delivered welding wire (Ø 0.9 mm),
the welding nozzle with the
17
labelling
0.9 mm must be used.