Parkside PFDS 33 B4, Инструкции по эксплуатации и безопасности

Страница: 39 / 141

39 GB/NI/IE
Assembly
†
Loosen the feed roll holder
30
by turning
it anti-clockwise and pull it upwards and
off (see Fig. G).
†
On the top of the feed roll
29
, check
whether the appropriate wire thickness is
indicated. If necessary, the feed roll has
to be turned over or replaced. The sup-
plied welding wire (Ø 0.9 mm) must be
used in the feed roll
29
with the specified
wire thickness of Ø 0.9 mm. The wire
must be positioned in the upper groove!
†
Erect the feed roll holder 30 again and
screw clockwise direction.
†
Remove the torch nozzle
7
by turning
it clockwise (see Fig. H).
†
Unscrew the welding
17
nozzle
(see Fig. H).
†
Guide the cable assembly
13
away from
the welding device as straight as possi-
ble (place it on the floor).
17
†
Take the wire end out of the edge of the
spool (see Fig I).
†
Trim the wire end with wire scissors or
a diagonal cutter in order to remove
the damaged, bent ends of the wire
(see Fig. I).
Please note:
The wire must be kept
under tension the entire time in order to
avoid a releasing and a roll out! There-
fore it is recommended to carry out the
work with an additional person.