Parkside PFBS 12 B6, Перевод оригинальной инструкции

Страница: 10 / 258

PFBS 12 B6
GB
│
IE
│ 7 ■
Safety instructions for all applications
General safety instructions for grinding, sand paper sanding, working with wire
brushes, polishing, milling and abrasive cutting
a) This power tool is intended for use as a grinder, sandpaper sander, wire brush,
polisher, milling machine and abrasive cutting machine. Please follow all safety
instructions, instructions, diagrams and data that you receive with the appliance.
If you do not observe the following instructions, this can lead to electrical shock, fire
and/or serious injuries.
b) Do not use any accessories that have not been provided or recommended by the
manu facturer for this power tool.
Just because you can attach the accessories to your
power tool, does not ensure they are safe to use.
c) The permissible speed of the accessory tool used must be at least as high as the
maximum speed specified for the power tool.
Accessories that rotate faster than the
permissible rate can break and throw pieces into the air.
d) The external diameter and thickness of the accessory tool used must comply with
the dimensions of your power tool.
Incorrectly dimensioned accessory tools cannot be
sufficiently shielded or controlled.
e) Grinding discs, sanding drums or other accessories must match the grinding spindle
or collet chuck of your power tool exactly.
Accessory tools which do not fit precisely
into the take-up of the power tool will rotate unevenly, vibrate severely and can lead to a
loss of control.
f) Discs, grinding cylinders, cutting tools or other accessories mounted on a mandrel
must be completely inserted in the collet or chuck. Any “protrusion” or exposed
parts of the mandrel between the grinding tool and the collet or chuck must be kept
to a minimum.
If the mandrel is not sufficiently tightened or the grinding tool protrudes
too far, the tool could come loose and be thrown out at high speed.
g) Never use damaged accessory tools. Before each use, check accessory tools such
as grinding discs for chips or cracks, sanding drums for cracks or excessive wear
and tear and wire brushes for loose or broken wires. If the power tool or the acces-
sory tool in use is dropped, check to see if it is damaged or use an undamaged
accessory tool. When you have checked and inserted the accessory tool, ensure
that you and any other people in the vicinity remain outside of the range of the
rotating accessory tool and allow the tool to rotate at maximum speed for one
minute.
Damaged accessory tools usually break during this test period.