Parkside PDT 40 B2, Инструкции по эксплуатации и безопасности

Страница: 31 / 37

31 GB
Introduction / Safety of the fastener driving tool
Recommended pressure
range:
4 to 7.5 bar
Air consumption per
drive in process:
approx. 0.13 litre per
driving-in process
Recommended lubricant: Compressed air special oil
Loading capacity:
100 pcs.
Nail lengths: 15 mm, 20 mm
25 mm, 30 mm,
32 mm, 35 mm,
38 mm, 40 mm,
45 mm, 50 mm,
Staple lengths: 10–40 mm
Staple width: 5.7 mm
Recommended
Hose diameter:
∅ 9 mm
Compressed air quality: Cleaned, oil-misted
and condensate-free
Noise and vibration data:
Measured values for noise are determined in ac-
cordance with EN 12549:1999, EN ISO 4871.
The A-weighted sound pressure level of the device is
typically 90.6 dB (A). Uncertainty K = 3 dB. The
sound level while working can exceed 103.6 dB (A).
These values are characteristic values referenced to
the device and do not reflect noise development at
the work location. Noise development at the work
location depends e.g. on the work environment, the
workpiece, the workpiece support and the number
of fastener driving processes.
In correspondence with conditions at the work loca-
tion, individual noise reduction measures may need
to be carried out, such as placing the workpiece on
a noise-suppressing surface, clamping or covering
to prevent workpiece vibration and adjusting to the
minimum pressure required by the work process. In
certain cases, wearing personal hearing protection
is require.
Wear hearing protection!
Vibration values in accordance with
ISO 8662-11:1999:
Vibration emission value a
h,D
= 12.380 m / s
2
Uncertainty K = 1.5 m / s
2
Mechanical impact (vibration)
The vibration value for the fastener driving device was
determined in accordance with ISO 8662-11:1999 —
Hand-held portable power tools – Measurement of
vibrations at the handle — Fastener driving tools
(see technical data). The value is referenced to the
device and does not represent the influence on the
hand-arm system when the device is used. Influence
on the hand-arm system when using the device de-
pends on e.g. gripping force, pressing force, work-
ing direction, air pressure set, the workpiece and its
position.
Safety of the fastener
driving tool
Please read all the safety
information and instructions. Failure to com-
ply with the safety instructions and instructions can
result in severe injuries and / or damage to property.
PLEASE RETAIN ALL SAFETY INFORMATION
AND INSTRUCTIONS FOR FUTURE REFERENCE.
Each time before starting work, check
for flawless functioning of the safety
and triggering devices as well as the
firm fit of all bolts and nuts.
Do not conduct any improper manipu-
lation of the fastener driving tool.
Do not dismount or block any part of
the fastener driving tool, such a trig-
ger lock.
Do not conduct any „emergency re-
pairs“ with unsuitable materials.
The fastener driving tool must be reg-
ularly and properly maintained as
specified by the manufacturer.
Prevent anything that would weaken
or damage the device, e.g. by:
– stamping or engraving,
Introduction