Parkside PDFP 500 B2, Инструкции по эксплуатации и безопасности

Страница: 7 / 47

7 GB
Safety advice
DANGER OF INJURY!
Never exceed the maximum allowable working
air pressure of 3 bar. Use a pressure reducer
to set the working air pressure.
DANGER OF INJURY! IMPROPER USE!
Never point the device at people or animals.
DANGER OF / EXPLOSION AND FIRE
SMOKING PROHI BITED!
Do not ignite
any sparks or open flames.
DANGER OF INJURY!
Never use oxygen or other combustible gas as
the energy source.
DANGER OF INJURY!
First disconnect the hose from the
compressed air source and only then
disconnect the compressed air supply
hose from the device.
This will ensure that
the compressed air supply hose does not wave
around or recoil in an uncontrolled manner.
For your own safety, wear suitable
personal protective equipment.
Wear
respiratory protection with active charcoal fil-
ters and goggles.
Keep children and other people away
while you are operating the device.
Distractions can cause you to lose control of
the device.
Disconnect the device from the compressed air
source before carrying out any repair or main-
tenance work, during interruptions to operations
and before transporting the device.
When removing the hose coupling, hold the
hose tightly in your hand to avoid injury
caused by the hose shooting backwards.
Look out for damage on the device.
Check the device for damage before bringing
it into use. Do not use the device if you discover
any defects.
Do not kink the device’s hose, otherwise you
may damage it.
Please note the safety instructions of the ma-
nufacturer of the sprayed material.
Remain alert at all times, pay attention
to what you are doing and use common
sense in your work. Do not use any de-
vice when you are tired or under the in-
fluence of drugs, alcohol or medications.
Do not remove rating plates or labels - they are
safety-relevant parts of the device.
If you are inexperienced in the use of this type
of device, you should seek out information or
training to learn how to handle it safely.
Q
Original accessories /
attachments
Use only the accessories and attach-
ments detailed in the operating instruc-
tions.
The use of accessories other than those
recommended in the operating instructions could
lead to you being in danger of injury.
Q
Safety instructions for
fine spray systems
Keep your work area clean, well lit
and free of paint or solvent containers,
rags and other combustible materials.
Potential danger of spontaneous combustion.
Keep fully functioning fire extinguishers / extin-
guishing equipment available at all times.
Ensure good ventilation in the spray-
ing area and sufficient quantities of
fresh air through-out the room.
Evapo-
rating flammable solvents create an explosive
environment.
Do not spray or clean with materials
with a flashpoint below 21°C. Use
materials on the basis of water, low-
volatile hydrocarbons or similar ma-
terials.
Highly volatile evaporating solvents
create an explosive environment.
Do not spray in the area of ignition sourc-
es such as static electricity sparks, open
flames, pilot lights, hot objects, motors,
cigarettes and sparks from inserting
and disconnecting power cords or the
operation of switches.
Such sources of sparks
can lead to ignition of the surrounding area.
Do not spray any materials for which
it is not known whether they pose a
danger.
Unknown materials can create dan-
gerous conditions.
Introduction / Safety advice