PDBNP 14 A1
■
14
│
GB
│
IE
│
NI
♦
Check if the diameter of the attached mouthpiece matches the
mandrel diameter of the determined rivet size.
♦
If it does not, unscrew the front connector using the assembly
spanner , if necessary.
CAUTION!
►
Ensure that the appliance is disconnected from the compressed
air source before you fit or remove the front connector .
♦
If necessary, unscrew the mouthpiece from the front connector
using the assembly spanner . Afterwards, screw the correct
spare mouthpiece into the front connector and tighten it.
♦
To attach the front connector , press it onto the thread (you will
feel minor resistance) and tighten it by hand.
♦
Tighten the front connector using the assembly spanner .
♦
Reconnect the appliance to the compressed-air supply.
♦
Place the rivet body in the drill hole.
♦
Slide the appliance over the rivet until the mandrel is fully insert-
ed into the mouthpiece .
♦
Pull the trigger . The mandrel is pulled into the device, detached
from the rivet body and the rivet joint is established permanently.
The mandrel falls into the pin collector .
If necessary, repeat the process until the mandrel has been fully
separated from the rivet body.
♦
Proceed in the same way with the other rivets .
♦
Empty the pin collector regularly.
♦
When you have finished working, disconnect the appliance from
the compressed air source.
Содержание PDBNP 14 A1
Страница 3: ...A B ...
Страница 27: ...PDBNP 14 A1 24 GB IE NI ...