Parkside PAHS 10.8 A1, Инструкции по эксплуатации и безопасности

Страница: 10 / 24

10 GB
Start-up / Maintenance and cleaning / Service centre General safety advice for electrical power tools / Before Initial Use / Start-up
not play with the appliance. Cleaning and user
maintenance shall not be made by children with-
out supervision.
Single use, non-rechargeable batteries must
never be recharged.
Before Initial Use
Removing / charging /
inserting the battery pack
Note:
The battery packed is delivered partly charged.
Charge the battery pack with the included charger,
ideally for a minimum of 3 hours. This will ensure
the battery delivers full power. Li-Ion batteries can
be charged at any time without reducing the life.
Interrupting the charging process does not damage
the rechargeable battery.
1. To remove the rechargeable battery pack
1
press the release buttons
2
and slide the bat-
tery pack
1
out of the unit.
2. Insert the mains plug into the mains socket. The
charge indicator
12
will light up green meaning
that there is a electrical connection.
3. Insert the battery pack
1
into the charger
13
.
4. As long as the battery pack is being charged, only
the red indicator
11
lights up. When charging
is completed, the red indicator
11
goes out and
the green indicator
12
lights up. The battery
pack
1
is ready for use.
5. Slide the battery pack
1
into the unit.
Checking the battery charge
The battery LED
10
indicates the status or remain-
ing charge as:
RED/ YELLOW/ GREEN = maximum charge/ power
RED/ YELLOW = medium charge/ power
RED = low charge – recharge battery
Start-up
Note! Always switch the hand grinder on before
applying it to the material, then apply.
Switching the unit on:
Press the ON / OFF switch
9
.
Switching the unit off:
Press the ON / OFF switch
9
.
Q
Vacuum dust extraction
DANGER OF FIRE! There is
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the
vacuum‘s dust bag) may ignite, e.g. as a result of
flying sparks generated when abrading metals or
metal objects left in wood. This can happen par-
ticularly if the wood dust is mixed with paint resi-
due or other chemicals and the abraded particles
are hot from prolonged abrasion. Therefore you
must empty the device’s dust collection box and the
vacuum cleaner’s dust bag before taking a break
or stopping work and always avoid overheating of
the abraded particles and the device.
Wear a dust mask!
Q
Dust box for internal
vacuum extraction
Mounting:
Slide the dust box for self-generated dust ext-
raction
5b
up to the stop on the hand sander.
Removal:
Press the release button 6 of the dust extraction
box for internal vacuum extraction
5b
and
withdraw it towards the rear of the device.
Note: Empty the dust collector in good time in or-
der to ensure the optimum removal of
5b
dust by
suction.
To do so, remove the dust box
5b
from the de-
vice as described above. Open the dust box
by pulling on the tab
5a
and remove the cover.
Now tap both parts to thoroughly clean them.