30 GB/MT
Operation
bolt them together in the following order: Flat
washers
17
a / retaining rings
17
b mounting
bolts
17
.
j
Place the drilling table
19
on the column
23
,
slide it fully downwards and fix it in position
with the clamp bolt
16
.
j
Fasten the vice
13
to the drilling table
19
with
the vice bolts
20
/ flat washers
20
a / nuts
20
b.
The elongated holes allow the vice to be fastened
in different positions. This allows different sizes of
workpieces to be clamped.
20
13
19
20
b
20
a
20
a
j
Place the pre-assembled motor unit
24
on to
the column
23
. Secure the motor unit
24
by
tightening the two hexagon socket head bolts
31
at the side using the Allen key
30
.
j
Attach the three drill lifting arms of the handle /
spindle guide
7
.
j
Open the chuck
3
and place it on the cone
of the drill spindle
4
. To attach the chuck
3
firmly and securely on to the cone of the drill
spindle
4
lightly tap the chuck
3
a few times
with a plastic hammer.
Insert the guard
5
into the mount and attach
it in place with the 3 bolts, retaining rings and
nuts in the mount.
The bottom part of the guard can be adjusted in
height.
j
Release the wing bolts, bring the bottom part
of the guard into the desired position and then
tighten the wing bolts again.
Q
Placing the bench press drill in
a suitable working position
j
Set the bench press drill down on a firm sur-
face and level it using a spirit level. We also
recommend that the machine is firmly bolted to
the supporting surface. Use the two holes in
the base plate
18
for this. Ensure that the base
plate
18
is not overstressed when bolted
down.
Q
Installation and bringing into
use
j
Check that the supply type, voltage and fuses
agree with those specified for the machine.
Q
Checking the V-belts
j
Unscrew the drive / belt cover locking screw
10
.
j
Open the drive / belt cover
6
. Check the ten-
sion of the V-belts
28
. It is correctly set when
the V-belt
28
can be squeezed in slightly.
E-3470_Table_Drill_PTBM500_Content_LB5.indd 30
17.03.2008 16:23:04 Uhr
