Parkside IAN 351750 2007, Перевод оригинальной инструкции

Страница: 14 / 134

PSSA 20-Li A1 GB
│
IE
│
9 ■
Use
Switching on and off
Switching on
♦ First press the safety lock-out and then the
ON/OFF switch . Afterwards, release the
safety lock-out .
Switching off
♦ Release the ON/OFF switch .
Adjusting the rotational speed
Press the ON/OFF switch lightly for a low
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.
Guiding the sabre blade safely
To adapt to the workpiece and for safe placement,
the footplate can be swivelled. It must always be
in contact with the workpiece when the appliance
is running.
Practical advice on sawing
♦ Check the material to be worked to make sure
that all foreign objects have been removed,
e.g. nails, screws, etc.
♦ Ensure that the ventilation slits are not
covered.
♦ Switch the appliance on before moving it
towards the material to be worked.
♦ Switch the appliance off immediately if the saw
blade jams.
Open up the sawn gap using a suitable tool
and pull out the sabre saw.
■ Use the appropriate saw blade and stroke
rate for the material to be worked.
■ Saw blades optimised for your sabre saw are
available from retail stores in different lengths
for various purposes.
■ Saw the material at a constant speed.
Sawing flush to edges
Using flexible saw blades with a suitable
corresponding length, you can saw off protruding
workpieces such as pipes flush to the wall.
Proceed as follows:
1. Place the saw blade directly against the wall.
2. Bend it by applying lateral pressure to the sabre
saw so that the footplate makes contact with
the wall.
3. Switch the appliance on as described and
saw off the work piece by applying constant
pressure.
Plunge sawing:
CAUTION! RISK OF KICKBACK!
■ Plunge cuts may only be made in soft
materials (wood or similar).
Proceed as follows:
1. Place the sabre saw with the lower edge of the
footplate onto the workpiece. Switch the
appliance on.
2. Tilt the sabre saw forwards and plunge the saw
blade into the workpiece.
3. Position the sabre saw vertically and continue
sawing along the cutting line.