Parkside IAN 351750 2007, Перевод оригинальной инструкции

Страница: 13 / 134

PSSA 20-Li A1 ■ 8
│
GB
│
IE
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Allow the battery pack to click into place
in the appliance.
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to check
the status of the battery (see also main diagram).
The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting/changing the saw blade
WARNING!
► Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury.
♦ Turn the quick-release chuck as far as the
stop and hold it in this position.
♦ Push the required saw blade into the
quick-release chuck as far as the stop.
CAUTION!
► The teeth of the saw blade must point
downwards!
♦ Let go of the quick-release chuck so that it
returns to its initial position. The saw blade
is now locked.
Adjusting the footplate
RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
♦ Adjust the footplate according to the cutting
depth.
♦ To do so, undo the locking lever and move
the footplate to the corresponding position.
♦ Lock this position by closing the locking lever .
Adjusting the pendulum stroke
♦ You can use the pendulum stroke switch
to adjust the pendular movement of the saw
blade . You can achieve fine, clean-cut edges
without pendulum movement (setting "0").
Deactivate pendulum movement when working
on thin workpieces. You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (setting "I").